Fuel Gauge Issue
#1
Registered User
Thread Starter
Join Date: Oct 2023
Location: Strasbourg, France
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Fuel Gauge Issue
Hello.
I have learned so much about my own sexuality through watching these live sex cams.
https://thegaywebcam.com/chat/69_aalpha_m0delfforyou1
https://asiancamsex.me/bj
https://hotfreesexcams.com/chat/charlottebrownxo
I have learned so much about my own sexuality through watching these live sex cams.
https://thegaywebcam.com/chat/69_aalpha_m0delfforyou1
https://asiancamsex.me/bj
https://hotfreesexcams.com/chat/charlottebrownxo
Last edited by HugoF; 03-16-2024 at 05:02 AM.
#3
New Member
iTrader: (4)
Do you have an aftermarket stereo installed? I would double check the AC/AMP Combo wiring. The analog signals from the fuel level senders (there's 2 of them) are sent to this combination computer module. This module interprets and converts the analog signal into digital and sends the data over the CANBUS to your gauge cluster. It's very rare for the gauge cluster stepper motors to fail (but still a possibility). I suspect your cluster is not receiving a signal from this module which is located under the Radio (head unit) and climate controls. Many aftermarket radios require the need to tap into this box for VSS. But it's also possible a wire or connector was damaged during a radio install even without the need to make a wire tape. This module is part of the process when installing aftermarket head units.
You would need some advanced diagnostic tools to verify if a digital signal is reaching the gauge cluster (professional shop), but you could use a basic multimeter to see if the analog signal is at least reaching the module. Get a copy of the FSM, it has all the wiring diagram details and should also include the desired/good signal parameters.
Good Luck!
-Icer
You would need some advanced diagnostic tools to verify if a digital signal is reaching the gauge cluster (professional shop), but you could use a basic multimeter to see if the analog signal is at least reaching the module. Get a copy of the FSM, it has all the wiring diagram details and should also include the desired/good signal parameters.
Good Luck!
-Icer
The following users liked this post:
bmccann101 (10-11-2023)
Thread
Thread Starter
Forum
Replies
Last Post
elijahinthez
Maintenance & Repair
0
07-23-2021 10:48 AM