Just got these delivered today. I will be doing the install on Saturday, can't wait.

Kinetix High flow cats.

 

Tanabe Sustec GF 210 spring. Drop is about 1 1/4" all around.]

 

Nice.

 

Pics after the drop. Good luck.

 

Make CERTAIN when you do the install, you FINGER tighten everything until it all lines up and doesn't hit the heat shiled over the cats. Only THEN can you tighten everything up.

Do NOT tighten up one side, then the other as you instll them, or you will be loosening them up, readjusting, then re-tightening.

 

I'll keep it in mind, how do you like yours? any raspiness?

 

Hey Matt, do you have personalized plates on your Z?
Where you messing around with a silver Z on rt 80 in NJ a couple weeks ago down by mount olive around exits 19 and 25?

 

Nope, no personalized plates. It wasn't me. I do drive the I-78, I-287, and I-80 routes quite often though.

I have seen a CS and a Redline at least a few times a week on 287.


As for the Cats. I LOVE them. I Used to have a TINY buzz, but ONLY around 5500 - 6000 RPMs, and ONLY when lifting off the throttle. After a few thousand miles, it is completely gone. I LOVE the sound of the combination of the Kinetixs cats and the Borla exhaust!