i have jl 300/2 amp, and i wanna wire it to jl 10w3v2, dual (2 sets of terminals)

i am not sure how to do the wiring to the sub itself. there are two sets of +- conenctors. do i run a + on one and a - from the other to the amp? do i need to also connect the remaining two to each other? someone let me know!

 

your sub didnt come with any wiring directions or diagram? anyways do you plan on bridging the amp or just running it off of one channel? to wire up the sub...connect one + wire to the - side on the speaker.then connect the other + terminal to the amp along with the - side..hope this helps

 

so... on the sub -+.............-+ like that?

+ on one side to the - on the other, then the remaining two to the amp?

 

 

(CKY4800 added the diagram while I was typing )

Look at page TWO of the JL 10W3V2 manual s the lower half of the page at the pictures. Take the SECOND row down which shows two subwoofers connecting to ONE amplifer. I'll assume that you're bridging the 300/2 amplifer to mono (there's a switch on it labled "bridging mode"). The 300/2 is rated down to 1.5 ohms so any of the right hand column configurations would work - choose the 2 ohm or the first one on the left hand column to give you 1.5 ohm.