Im about to go outside and install my new kenwood ddx7017

This deck has automatic switching to the rear camera input when the car is put in reverse, but you are required to connect the wire to the "Vehicle's Reverse Lamp Harness"

My question is, where the heck is that!?! Please someone help me out if you know!

 

I intercepted mine in the left wheel well to avoid running wires though the already tight console area. My "brain" is mounted under the passenger's seat. It's just behind the strut bar area so if you take out that piece of plastic - the one that forms the bottom of the triangle window - you'll see three jacks running to the harness back aft.

The wire does run though the left kick panel somewhere ... I didn't want to go there because of the "fine" job the Nissan dealer did with the installation of my alarm system.

You can see the safety pin in the jack from testing.



Here's a close-up.

 

thanks, mine will actually be coming from the dash bc its a DD with brain in dash too, but thanks very much! i should be able to get it just fine now