ok so i bought Infinity 6010 CS speakers and installed them in stock door area with the stock wireing and amp... i then bought a sub enclosure, a 1052 w 10 inch sub with 250 watts RMS and 1000 peak watts, i also bought the Infinity 7541 a 4 channel 656 watts max power with 111W RMS x4...i also bought a 4 GA grounding kit and a 4 GA power kit with fuse...now along with RCA cables, what else do i need to buy if i plan on just power the sub through the box...also how about if i want to use stock speaker wire and wire my speakers into the amp???what would i need then??


by the way...the search function is not working so sorry i couldnt look this up

thanks a lot

 

run new wires to where the front speakers from the amp. all you need is a power cable with fuse, a ground cable, 2 sets or rca's, a remote turnon wire from the deck or power antenna connection. wire the front two subs to the front connections on amp and bridge(a positive from left and a negative from the right) the back two channels to the sub .

 

as long as the sub has a 4 ohm voilc coil

 

yea it has dual 4 ohm voice coils

 

make sure ur amp is cool running 2 ohms all the time

 

yea it says it is fine running 2 ohms

 

yea but not 2 ohms bridged..... just wire it like i said