Pioneer Nav system parts pics
#61
Registered User
Thread Starter
Join Date: May 2002
Location: Honolulu
Posts: 2,774
Likes: 0
Received 0 Likes
on
0 Posts
Hmm, sorry, the whole thing is installed now. It was fairly straightforward though, just place one end pointing toward the little clear palstic diffuser and the other end where ever you want.
#63
Registered User
Thread Starter
Join Date: May 2002
Location: Honolulu
Posts: 2,774
Likes: 0
Received 0 Likes
on
0 Posts
Here's a link to the second part of this thread where I actually get everything installed.
Hope it answers some questions.
Pioneer install part II
Hope it answers some questions.
Pioneer install part II
#64
Registered User
Join Date: Dec 2004
Location: San Diego, CA
Posts: 577
Likes: 0
Received 0 Likes
on
0 Posts
My big problem now is with wiring. My understanding of the Z's electrical wiring is limited at best. I have the service manual, but I can't make head or tails of most of the wiring diagrams. Specifically, I need to know the following.
- How do I find the car speed wire? What's the best place to get to it?
- Where is the handbrake lead? I assume it's by the handbrake, once the console is off, I hope I can find it.
- Are there easier places to access the backup lamp lead than at the rear lights?
- I need a power lead that is always on. How would I best connect the nav portion of the wire to it? The above three wires have built in splicers, the below wires are just free leads.
- I need the wire which is one with ignition, and again, the same question as above.
- Lastly, how do I identify the lighting wire?
Again, these are pretty basic, dumbass questions, but I'm a pretty basic dumbass when it comes to this kind of stuff.
Any help would be greatly appreciated. I hope we can get this to be the definitive nav installation thread.
Thanks! Andrew
- How do I find the car speed wire? What's the best place to get to it?
- Where is the handbrake lead? I assume it's by the handbrake, once the console is off, I hope I can find it.
- Are there easier places to access the backup lamp lead than at the rear lights?
- I need a power lead that is always on. How would I best connect the nav portion of the wire to it? The above three wires have built in splicers, the below wires are just free leads.
- I need the wire which is one with ignition, and again, the same question as above.
- Lastly, how do I identify the lighting wire?
Again, these are pretty basic, dumbass questions, but I'm a pretty basic dumbass when it comes to this kind of stuff.
Any help would be greatly appreciated. I hope we can get this to be the definitive nav installation thread.
Thanks! Andrew
I'm looking for Speed Sensor, Reverse and Parking Break
Thanks!
Yes -- yes -- very old thread -- Help?
Thread
Thread Starter
Forum
Replies
Last Post
Justin100
Intake Exhaust
26
11-29-2015 03:58 PM
350Z Project X
Suspension
9
10-10-2015 09:23 AM