FS: 10" Corner Box w/ Pioneer Flat
10" Corner Box w/ Pioneer Flat
Had this in the Z for a few years, sounded amazing and the corner box was very convient by still allowing access to under the strut bar.
the Box is your typical corner box made of MDF and wrapped in carpet which matches well to the black Z interior. It was purchased from zenenclosures. No air leaks or any other issues.
I matched a Pioneer TS-SW2501S4 10" setp up shallow S4 subwoofer.
This was done because the corner box only has .43FT volume and the subwoofer only need .35 which made it a ideal match.
I had it powered by a 300W amp and it was very loud. I basically ran it on 1/4 power the majority of the time.
Im in the setup close a little over $200.
would like to get $125shipped on it.
Im located in Roseville, CA if anyone is local. About 20-30 minutes from Sacramento and 1.5-2hours from SF.
the Box is your typical corner box made of MDF and wrapped in carpet which matches well to the black Z interior. It was purchased from zenenclosures. No air leaks or any other issues.
I matched a Pioneer TS-SW2501S4 10" setp up shallow S4 subwoofer.
This was done because the corner box only has .43FT volume and the subwoofer only need .35 which made it a ideal match.
I had it powered by a 300W amp and it was very loud. I basically ran it on 1/4 power the majority of the time.
Im in the setup close a little over $200.
would like to get $125shipped on it.
Im located in Roseville, CA if anyone is local. About 20-30 minutes from Sacramento and 1.5-2hours from SF.
Thread
Thread Starter
Forum
Replies
Last Post