Was wondering if you guys could help me out. Tonight I installed some Hotchkis springs and I had to reinstall the Tower Bar. I looked in the Service manual but really don't understand the proper way to adjust the Bar. Can you guys simplify it for me? Thank you in advance.

 

*Bump*

 

It's pretty basic.

1. Make sure the bar is back in position and the mounts are tightened down properly.
2. Make a mark (felt pen works best) on the center nut as a reference point.
3. Make sure the 2 outside locking nuts are close to the center nut so they don't bind up when you turn the center nut.
4. Rotate the center nut with a wrench by pulling towards the front of the car. Rotate it roughly 1.75 turns.
5. Screw the 2 locking nuts outwards (away from the center) and tighten with a second wrench while holding the center nut in place with a wrench.

 

Cool, That makes perfect sense. Thanks for your help.