So, I got the Project Mu B-Force brake pads for the front and rear a couple months ago, and I want to put them on finally. So I was wondering, should I do all 4 corners at the same time? Or should I do the front or back, then go out and do the bedding process, and then do the other axle, and then do the bedding again? Or does it not matter? Thanks in advance for your help.

 

It dosent matter. Do them all at the same time.

 

I did all 4 at the same time. I think it allows them all to bed the best IMO.

 

My fronts went out at 20.5k, i bought all four pairs, and replaced just the fronts since the backs were fine. i can almost hear the backs whistling now at 22.5k, so i guess i'll have to do the backs soon...