Gettin ready to install my Stance coilovers. What have you guys used to hold up the ABS Lines???

 

Zip tie

 

yep, Zip Tie works quite well on my Buddy Club coils.

 

Awsome guys. Thanks. Any other things i need or have to watch out for when installing coilovers???

 

yes, make sure you slam your car

Stance Coilovers

 

pimp! Installs been cancelled. Opened one of my rears and the damper adjuster is bent. Gotta send it back.

 

oh you just got the rear lifted up in that pic huh

 

good luck on ur install, tell me how it goes, tell me if your car squeaks cause i got stance too and mines squeaks on the rear passenger kinda mad about it but imma find some how to stop it. if you knoe tell me how to fix the squeak thx man

 

It'll take a few weeks, like i said, gotta send one of the fronts back. The damper adjuster was bent. Pisses me off cuz i waited a month for em.

 

That sucks, But do a write-up after you install and test them. I'm interested in those coilovers...Probably going to end up upgrading to the stances

 

yea im kinda dissappointed in it cause of all tat squeaking, hope it doesnt happen to yours but make sure you update on what happen

 

guys have you set proper preload as well as lube it up a lil?
also make sure the top nut is tightened as well.

 

where do we lube it? and how do you preload?

 

^ preload is when you raise the collars just below the spring upwards.

 

How do i know how much to set the preload??? It says to tighten by hand, then use the wrenches to turn 2 full revolutions. Will this have anything to do with the height as well?

 

Got them installed. Any one know the stock heights for the fronts? For some reason my drivers side sits 1/4" lower than my passenger side.

 

yeah, what jinsei posted......make sure you slam it like crazy! i almost slammed mine: senjen's g35 pics. as far as your height goes, i'd take the coilovers out, and measure them. re-inspect that the top strut nut is tightened, and ensure that the preload is the same for both sides. then re-install and see.

 

yep

 

how much did it cost you??? for the stance coilovers?

 

i'm in canada... paid 1400. tougefactory. pics comin up soon.