Ok heres the story. I had RS-R springs on, but my front tires were wearing out to quickly because my camber was out. So i went ahead and installed my factory springs on the FRONT, and as I was about to do the rear when I noticed the car doesnt actually look bad with the RS-Rs still on the rear. I know the RS-Rs rear spring rates are very close to the 2004.5+ spring rates, and it only lowers .6 inches. Any reason I should take them off the car and put the factory rear springs back on? Or is it ok to leave them on?

 

Can you post a pic of this set-up?

 

2003 350Z. Stock front springs, RS-R REAR springs

 

Front needs a drop man, it looks off...

 

hard to tell in that pick but i wouldnt risk it in any case.. swap em out...

 

well its either keeping these REAR springs on or go back to stock REAR springs

 

outside of spring rates, it might help w/ weight balance...moves some of the weight to the rear