might install Tanabe SUSTEC GF 210 Springs
10-03-2007, 09:04 AM
#1
Registered User
Thread Starter
iTrader: (18)
Join Date: May 2006
Location: Florida
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
might install Tanabe SUSTEC GF 210 Springs
i am thinking about installing these Tanabe SUSTEC GF 210 Springs.
i have 20" rims on the rear of my 350z. the drop is -1.0" front and -1.2" rear. i have a camber and toe kit from SPC. is there anything else i need to know about installing these springs? i expect the rear will tuck a little, which is what i want. any input would be appreciated. thanks
i have 20" rims on the rear of my 350z. the drop is -1.0" front and -1.2" rear. i have a camber and toe kit from SPC. is there anything else i need to know about installing these springs? i expect the rear will tuck a little, which is what i want. any input would be appreciated. thanks
Last edited by Z350MAN04; 10-03-2007 at 12:26 PM.
10-03-2007, 10:09 AM
#2
Registered User
Thread Starter
iTrader: (18)
Join Date: May 2006
Location: Florida
Posts: 137
Likes: 0
Received 0 Likes
on
0 Posts
is this spring rate date correct?
Coupe:
03/04 unrevised rear springs have 2 red dots and one white dot or all red dots. (342lbs in rate)
04.5-06 revised rear springs have 2 red dots and one light purple dot. (427lbs in rate)
Coupe:
03/04 unrevised rear springs have 2 red dots and one white dot or all red dots. (342lbs in rate)
04.5-06 revised rear springs have 2 red dots and one light purple dot. (427lbs in rate)
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
