I've got the Ichiba front Camber kit, and was about to install this morning, when i realized my OE Upper control arm had that "Ball Joint SEAT" pictured

http://www.courtesyparts.com/40173a-...8-p-15696.html

that my Camber kit didn't.. Now, so far from what i've read, you'd got to use some kind of Claw to Pull the "SEAT" off?? And i'm assuming it will just slide right up to the new camber kit right?? Probably by placing it on there and tightening it up??

Any info or previous write ups will be greatly appreciated. TY guys!!

 

http://www.youtube.com/watch?v=ju4aN...layer_embedded