Forged Performance Open House/Dyno Day Vid
Thread Starter
Sponsor
Forged Performance
Forged Performance
iTrader: (92)
Joined: Dec 2003
Posts: 13,733
Likes: 1
From: Marietta, GA
We had another great open house this weekend. About 60 cars throughout the day, lots of free food and drinks, and 30 cars ran the dyno. We made a little vid...hope you enjoy! 
http://www.youtube.com/watch?v=b20Idnu9PB4

http://www.youtube.com/watch?v=b20Idnu9PB4
Originally Posted by Sharif@Forged
We had another great open house this weekend. About 60 cars throughout the day, lots of free food and drinks, and 30 cars ran the dyno. We made a little vid...hope you enjoy! 
http://www.youtube.com/watch?v=b20Idnu9PB4

http://www.youtube.com/watch?v=b20Idnu9PB4
You can post the actual video in the media section of the forums.. And embed the code so we dont have to go to youtube to watch it..
Thread Starter
Sponsor
Forged Performance
Forged Performance
iTrader: (92)
Joined: Dec 2003
Posts: 13,733
Likes: 1
From: Marietta, GA
Kenk, I am not sure how to do that....lemme know, and I will do it.
Thanks guys...we do the open houses twice a year, so the next one will likely be in Sept.
Thanks guys...we do the open houses twice a year, so the next one will likely be in Sept.
Originally Posted by Sharif@Forged
Kenk, I am not sure how to do that....lemme know, and I will do it.
Thanks guys...we do the open houses twice a year, so the next one will likely be in Sept.
Thanks guys...we do the open houses twice a year, so the next one will likely be in Sept.
There is 'embed' code on youtube, streetfire etc that allows you to do this..
Here is your 'embed' code from youtube..
Code:
<object width="425" height="350"><param name="movie" value="http://www.youtube.com/v/b20Idnu9PB4"></param><param name="wmode" value="transparent"></param><embed src="http://www.youtube.com/v/b20Idnu9PB4" type="application/x-shockwave-flash" wmode="transparent" width="425" height="350"></embed></object>
There are only certain parts of the forum that can actually do this.. Basically if you look at the bottom left portion of the page you will see that HTML code is either turned 'on' or 'off'. If its turned 'on' than you can embed. If its off, then you cannot do it. Only 2 parts of the whole site are aloowing this.. The Media share and the Anything Goes sections of the site.








OOPS!!!! Dammit.... not again