UR Pulley voltage drop
#1
Registered User
Thread Starter
iTrader: (6)
Join Date: Oct 2005
Location: losAngeles
Posts: 753
Likes: 0
Received 0 Likes
on
0 Posts
UR Pulley voltage drop
So, about a month ago I installed the UR Underdrive pulley. One thing that I noticed is that my battery voltage drops whenever I am stuck in stop and go traffic for a while and sometimes it drops so low that the Z shuts down. Today it sorta freaked me out because it the voltage dropped when I was getting off the freeway. The car died as I entered the off ramp and I almost went into a wall without my power steering.
Is there anything that I can do to keep the voltage from dropping and shutting down the car? Would a different battery help? Should I tighten the belts more? Would a grounding kit do anything?
Help me out fellas
Is there anything that I can do to keep the voltage from dropping and shutting down the car? Would a different battery help? Should I tighten the belts more? Would a grounding kit do anything?
Help me out fellas
#2
hatersgonnahate
iTrader: (162)
its not the pulley. Its probably your alternator or battery.
I had the UR pulley, it only underdrives by 15%. You may see a volt or two less on the gauge, but that can be attributed to heat as well. I never had voltage issues, even with the low idle.
I had the UR pulley, it only underdrives by 15%. You may see a volt or two less on the gauge, but that can be attributed to heat as well. I never had voltage issues, even with the low idle.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM