clutch and flywheel change
07-27-2008, 08:06 PM
#1
Registered User
Thread Starter
Join Date: Mar 2008
Location: Wethersfield, CT
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
clutch and flywheel change
so this weekend i began doin all kinds of things to my 350z. i began doin the sways bars, did a tune up, changed belts, the rear diff, the exhaust. also with all this i was changing out the clutch and flywheel. after dissambling everthing and then puttin it all back together of course an issue came up. 
now everything was checked a bunch of times and what happens now is that it does start up but it runnin rough and then cuts off. before i even started the removal of the tranny. i had the car running perfectly fine after the tune up and belts change. i think that the crankshaft position sensor is no good anymore cuz it made its way to the floor when i was ready to put it in.
is the sensor that sensitive that it could be my issue. it really seems like is might be, but im not positive. any ideas?
now everything was checked a bunch of times and what happens now is that it does start up but it runnin rough and then cuts off. before i even started the removal of the tranny. i had the car running perfectly fine after the tune up and belts change. i think that the crankshaft position sensor is no good anymore cuz it made its way to the floor when i was ready to put it in. is the sensor that sensitive that it could be my issue. it really seems like is might be, but im not positive. any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM