Fuel Gauge Acting Up!
Thread Starter
Registered User
iTrader: (1)
Joined: Mar 2008
Posts: 142
Likes: 0
From: Dominican Republic
My Gauge is starting to act up...
Today I topped the tank and my gauge shows 1/2 tank...after 10 mins of driving the gauge started to move slowly to the full mark...after shutting the car off and restart the gauge is showing 1/2 tank again...
I searched but no answers...any help???
The fuel pump was not removed from car...
Is this a Difficult work? I dont want to take the car to the dealer..
Should I remove the Whole Pump assembly to check if a wire or something is messed? Any Instructions on how to remove it? thanks
Today I topped the tank and my gauge shows 1/2 tank...after 10 mins of driving the gauge started to move slowly to the full mark...after shutting the car off and restart the gauge is showing 1/2 tank again...
I searched but no answers...any help???
The fuel pump was not removed from car...
Is this a Difficult work? I dont want to take the car to the dealer..
Should I remove the Whole Pump assembly to check if a wire or something is messed? Any Instructions on how to remove it? thanks
what would you do if you found a "messed" (up?) wire? would you solder a wire on your fuel pump........ or......
if you do not know what you are doing, i would encourage you to not attempt this procedure.
if you do not know what you are doing, i would encourage you to not attempt this procedure.
Thread Starter
Registered User
iTrader: (1)
Joined: Mar 2008
Posts: 142
Likes: 0
From: Dominican Republic
Where do i say that i will solder or anything like that...I meant that if there is a pinched wire of something..Btw I wont do anything that i dont know how to...
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
Nov 9, 2020 10:27 AM




