This Can't Be Normal: VQ35DE Power Steering Pulley
#1
This Can't Be Normal: VQ35DE Power Steering Pulley
The bracket that helps secure my power steering pulley has a small space between it and the block that will not close. I tried tightening the bolt that holds it onto the block at the very location where the space is, and it's not doing anything. I can't tighten it any more or else I will strip it.
Is the space between the pulley bracket and the block normal on the DEs? The pic below is of Adam at Z-1 Performance's motor, and I have used two arrows to point to the location of the gap.
If anyone would do me a favor and look at that bracket on their car and report back, I'd really appreciate it.
Is the space between the pulley bracket and the block normal on the DEs? The pic below is of Adam at Z-1 Performance's motor, and I have used two arrows to point to the location of the gap.
If anyone would do me a favor and look at that bracket on their car and report back, I'd really appreciate it.
Last edited by blackfairlady; 12-17-2008 at 05:37 AM.
Thread
Thread Starter
Forum
Replies
Last Post