pin 13 Crank position sensor,wire color??
#1
Registered User
Thread Starter
Join Date: Jun 2008
Location: Savannah, Ga.
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
pin 13 Crank position sensor,wire color??
Here is the question I am serch of the pin number 13 crank position sensor,i have found what i believe is the correct pin slot ,but the wire is green with a red line ,can anyone confirm for me that i ahve the correct wire ,and if not please if you know what one i am looking for help please,thanks O ya i have an 05 enthus.
Last edited by scout35316; 12-21-2008 at 01:04 PM. Reason: lacking info
#2
Registered User
Thread Starter
Join Date: Jun 2008
Location: Savannah, Ga.
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
problem solved ,its blue and white, and my WOT box works like a champ, launch control,and flat foot shift,pretty bad *** but im sure im gonna break something now !
#4
Registered User
iTrader: (1)
Join Date: Dec 2007
Location: Northern Jersey
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
hey i was wondering if you could help me out? i bought the WOT box too and i wired everything up to the sensors. I the the blue wire running to the APP sensor by the gas pedal, The green wire running to the upper clutch switch, i tapped into the coil packs wire and i ran the yellow wire to the crank position sensor at the bell housing. The wire is tapped into the white/brown middle wire which is the signal. My no lift to shift works but my 2 step dont work. I was wondering if you could help me out or take a pic for me of how you have it wired. By the way i have an 05 coupe
#5
Registered User
iTrader: (1)
Join Date: Dec 2007
Location: Northern Jersey
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
hey i was wondering if you could help me out? i bought the WOT box too and i wired everything up to the sensors. I the the blue wire running to the APP sensor by the gas pedal, The green wire running to the upper clutch switch, i tapped into the coil packs wire and i ran the yellow wire to the crank position sensor at the bell housing. The wire is tapped into the white/brown middle wire which is the signal. My no lift to shift works but my 2 step dont work. I was wondering if you could help me out or take a pic for me of how you have it wired. By the way i have an 05 coupe
#6
Registered User
Thread Starter
Join Date: Jun 2008
Location: Savannah, Ga.
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
lookthatsme... hey i just pm'ed you ,if that doesnt help i gave you my number hit me up and if last but not least that doesnt work ill take mine back apart and take you some good pictures......
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM