Haltech not sending power to racepak
Haltech not sending power to racepak
The title pretty much says it all. I hooked up my racepak, plugged it in to my haltech's CAN port, and nothing. The racepak won't turn on and when use the Haltech ECU manager to look at the ECU, it's not reading the device in the can bus area. Could this be a wiring issue (I tried to follow the provided instructions as best I could) or I got a bad unit or what? Any help, ideas, etc would be greatly appreciated. I really wanna be able to drive my car again Lol
Yeah, wasn't sure where to post this since there isn't really a place for ECU type errors. Figured I'd at least give interiors a shot, on the off chance that the problem is with the Dash itself and not the ECU. It seems to be a common topic of discussion on the interiors section.
But thanx for the heads-up. I tired calling and getting on the Haltech forums but they were both a no-go. Couldn't find an email, so I guess it's time for some PMing
But thanx for the heads-up. I tired calling and getting on the Haltech forums but they were both a no-go. Couldn't find an email, so I guess it's time for some PMing
Last edited by AmnCruzie; Dec 17, 2011 at 09:49 PM.
This, Hal is very helpful.
Yeah, I understand. Always the "tuning" or if you have boost, "force induction" sub forums. A lot of helpful guys in those sections.
Yeah, wasn't sure where to post this since there isn't really a place for ECU type errors. Figured I'd at least give interiors a shot, on the off chance that the problem is with the Dash itself and not the ECU. It seems to be a common topic of discussion on the interiors section.
But thanx for the heads-up. I tired calling and getting on the Haltech forums but they were both a no-go. Couldn't find an email, so I guess it's time for some PMing
But thanx for the heads-up. I tired calling and getting on the Haltech forums but they were both a no-go. Couldn't find an email, so I guess it's time for some PMing
