I'm looking to pick up a spare OEM Clutch/FW for my HR.
I found this set off a G37 with 27K mi.
They use the same clutch as HR. The FW also fits (weighs 2 lb more).
Please only comment on the condition of these (surfaces)...don't want opinions on OEM vs aftermarket
Seller say the spots are not glazing and fine sandpaper will do the trick.
The disc looks very good as well..lots of meat left..no glazing that I can see .

Thanks...





DISC looks fine:


For a comparison...
Here another FW from an HR. Looks different on edges, but I guess that's why it LIGHTER (less materail).

 

Is this what you emailed me? I saw the email but forgot to reply. Radiology section of licensing boards today.

This looks good. 50$ in machining to the flywheel and pressure plate will true it up and take that glaze off.

 

Update.

Decided to go with lower Mi kit (5K mi on it)..also has CSC and Tubing in very good condition as well.
You can see the difference in the surfaces...no *spotting* and disc look in better shape too. All this COMPLETE KIT for $240 SHIPPED!
The flywheel is 2lbs heavier on the G37/370s due to more torque over HR, but my HR has same HP/TQ as these with all my mods.

What I got:

 

Know what that's like

 

Ya, the diseases weren't bad but the film quality was poor. Not a single radiologist would have accepted those films at our hospital.

Primary care is a pain.