quest for 12's
alright guys im running an 05 base model with jwt popcharger 5/16 plenum spacer resonated test pipes custom y pipe stock muffler and resonator up rev tuned and a 75 wet shot (sadly its open diff) with 255 sport comp 2's this weekend went to the strip managed to pull out a 13.2 and two 13.3 runs with pretty consistant 2.0 60 foot times.. unfortunately im never happy and want 12's what do u think a reasonable next mod would be to get closer
350z was never meant as a drag car. They cant hook/launch worth a damn. Honestly either sell the z and get a different car, or up your spray and lighten your load. Get bigger tires to improve launch.
Trending Topics
what are people on drag radials running for 60ft times? im still running stock wheels so biggest i could go would be like a 255 dr not really sure it would be worth the time but im stuck in this car for about another year and a half before payments gone. then go the route travlee went those z06 are monsters
I think you need to practice your launch, there are plenty of people with boltons and stock running your times and better, I would think with a 75 shot you should be running 13 flat at least, but depends where your located too..
how are sidewalls with 275's? and i honestly dont think with the current set up i could launch any harder hell im only a tenth away from my buddys gc srt8 to 6 foot and about the same at the big end only i trap 4 mph faster. the killer is i cant spray until 3rd and control wheelspin was thinking about picking up 255 hankook rs'3 on the rear see how that helps
Yeah sounds like you just need better traction then I would say get some dr's or something a lot stickier as a street tire the hankooks are a good choice though, but you may be able to squeeze a bit more out of your tune as well.
How are factory lsd's could get entire center section fairly cheap if is worth while? I do need to get back on dyno when i spray the engine bogs first then takes off see if i can get that worked out have a fairly hefty fuel jet im thinking my need to downsize
Thread
Thread Starter
Forum
Replies
Last Post








