I'm about ready to purchase the Veilside Ver.3 body kit with fender flares but I'm not sure what rime width size I will need with this kit. 20in Volk GT-C's is what I will like to go with. Can someone help me in determining the wheel size that will work with this kit and will I need spacers?

Also, will the original fender need to be cut, to accommodate the 20in wheel?

Thank You in advance.

 

wheel size is not what you should worry about. YOu should worry about the offset. What is your GT-C offset? The flare will comes out from your fender about 10-15 mm. You can add wheel spacer to make it looks flush.

 

Here is the offset chart for this wheel. Maybe this could help? Thanks

http://www.mackinindustries.com/md/r...c_spec.jpg.gif

 

what's the point of going widebody then if you're just gonna put on a 10.5 inch wide rim and having spacers?

call Mackin and have them custom make you a set of 20x13.5's for the rear.

 

20x11 in the rear would be fine too.

Recommended Wheel Fitment with Version 3 Overfender Kit:

Front: 20 x 9.0J (+18mm)

Rear: 20 x 11.0J (-18mm)