ATTENTION Aluminum fabricators... need your help.
#1
Registered User
Thread Starter
ATTENTION Aluminum fabricators... need your help.
I'm looking to have a piece created for the throttle pedal that will widen it by ~.5" for heel/toe on the track. See picture below for something similar developed for the RX-7.
Here's the article that shows more of the pedal design.
I have to have a wider pedal because of my seating position (looooong legs, normal arms) and cannot rotate my foot, rather I need to roll it off the brake. The current gap between brake and throttle is just a bit too wide. If someone is interested in taking this on I'll provide more details as to my design ideas.
Thanks!
Brad
Here's the article that shows more of the pedal design.
I have to have a wider pedal because of my seating position (looooong legs, normal arms) and cannot rotate my foot, rather I need to roll it off the brake. The current gap between brake and throttle is just a bit too wide. If someone is interested in taking this on I'll provide more details as to my design ideas.
Thanks!
Brad
#5
Registered User
Join Date: Oct 2002
Location: Mesa,AZ
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
I could have one CNC'd out of 6061 for you if interested.
problem is.. unless I make 10 or more the cost is not friendly.
About $60 for one or $30 if 10 or more are fabricated.
problem is.. unless I make 10 or more the cost is not friendly.
About $60 for one or $30 if 10 or more are fabricated.
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM
CFAUVEL
Exterior & Interior
3
10-01-2015 03:20 PM