I'm looking to have a piece created for the throttle pedal that will widen it by ~.5" for heel/toe on the track. See picture below for something similar developed for the RX-7.



Here's the article that shows more of the pedal design.

I have to have a wider pedal because of my seating position (looooong legs, normal arms) and cannot rotate my foot, rather I need to roll it off the brake. The current gap between brake and throttle is just a bit too wide. If someone is interested in taking this on I'll provide more details as to my design ideas.

Thanks!
Brad

 

i have a base model, so id be in if it werent too much.....

 

It may just be better to adapt another current pedal. Stamping out that funny shape with depressed and/or raised portions would be too spendy to make.

 

try www.racepedals.com

 

I could have one CNC'd out of 6061 for you if interested.

problem is.. unless I make 10 or more the cost is not friendly.

About $60 for one or $30 if 10 or more are fabricated.