anyone know what mounting brackets they used on the Rotora wing on the AEM 350z drifter? they are alot bigger that the ones Rotora provides and are a solid design rather than the what i think to be the flimsy bracket that comes with the wing stock, the wing also has larger side panels not sure if those were fabricated or not anyone know? thanks heres a pic:

 

ricealicious

 

that wing has to be chopped. doesnt look real.

 

Considering its a custom built drift car by a major company , i'll have to bet its a one off setup made for them.

 

you don't get modifiedmag then...there was a huge article about that car a few issues ago

the thing that bothers me about that car is the nasty constant hood pop. looks like they put risers so that the hood is intentionally not lining up for ventilation. not my thing, but then again, i'm not a drifting champion.

 

Oh.. its real.. and the sides of the wind are .. dumb IMHO.


The hood has been spaced in the rear to allow for more airflow to pass thru, and cool the engine better.

 

Huge GT wing = Huge sushi bar IMO

 

i think the huge gt wing looks sick almost like a dragster look which is more of a complement then anything right i mean since top fuel's have alot of poneys under the hood.. so wing= rotora but the side pannels and brackets= fabricated.. gotcha