I've searched and searched, need Titek duct template
#1
New Member
Thread Starter
iTrader: (5)
Join Date: Nov 2003
Location: LA
Posts: 519
Likes: 0
Received 0 Likes
on
0 Posts
I've searched and searched, need Titek duct template
Maybe make this into a sticky or something? Or put TITEK DUCT TEMPLATE into the title so it is easily found (like I did)?
Anyhow, does anyone have the template for the Titek carbon fiber duct? I got one used, searched for about 15 minutes using several combinations of words and nothing useful is found (Titek, carbon, duct, template, air, intake).
Some one want to post a PDF or a 1:1 scale template so I can get to cutting?
Thanks in advance.
Anyhow, does anyone have the template for the Titek carbon fiber duct? I got one used, searched for about 15 minutes using several combinations of words and nothing useful is found (Titek, carbon, duct, template, air, intake).
Some one want to post a PDF or a 1:1 scale template so I can get to cutting?
Thanks in advance.
#2
Registered User
iTrader: (46)
I found that the Titek template was way off. I went ahead and made some changes to the Varis template to accommodate my Titek install.
Follow these steps (I take no responsibility for you adversely damaging your bumper cover):
-Print off the file using Microsoft Fax and Picture Viewer
-Print as a Full Page Fax Print (first option). This shrinks it enouch to work with the Titek duct since the Varis has a larger "opening".
-Make sure the lines match up with bumper and light
-Make cuts following the red lines that I added, as squaring off the edges will not work with the Titek.
-Be cautious and continue to trim to fit.
EDIT: This is meant to serve as a guide, not necessarily a cutting template. Use at your own risk.
Follow these steps (I take no responsibility for you adversely damaging your bumper cover):
-Print off the file using Microsoft Fax and Picture Viewer
-Print as a Full Page Fax Print (first option). This shrinks it enouch to work with the Titek duct since the Varis has a larger "opening".
-Make sure the lines match up with bumper and light
-Make cuts following the red lines that I added, as squaring off the edges will not work with the Titek.
-Be cautious and continue to trim to fit.
EDIT: This is meant to serve as a guide, not necessarily a cutting template. Use at your own risk.
Last edited by jtabraham; 11-05-2007 at 12:48 PM.
#4
New Member
Thread Starter
iTrader: (5)
Join Date: Nov 2003
Location: LA
Posts: 519
Likes: 0
Received 0 Likes
on
0 Posts
The bumper is going under the knife this weekend, I'll let you know.
I did open the template, re-sized it in Photoshop to 8.5x11 and it looks close enough. Start small and open the hole up and test fit, repeat until it fits. Thanks again for the file. It really helps with the alignment to the lights and hood seam.
I'll post some pics after I finish
I did open the template, re-sized it in Photoshop to 8.5x11 and it looks close enough. Start small and open the hole up and test fit, repeat until it fits. Thanks again for the file. It really helps with the alignment to the lights and hood seam.
I'll post some pics after I finish
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
Colombo
Forced Induction
35
11-09-2020 10:27 AM