When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Yeah, the pictures cheston provides where the brackets go is just unclear and he even admits that they're hard to find. It would be much more helpful if someone posted pics. Do the brackets need to be bent?
Julian can you post a picture of your bracket setup? Did you use the same brackets mastergrade provides? Also, did anyone dremel the inside of the diffuser where it meets under the bumper to get it to sit flush?
The brackets are completly off, I will agree..The driver side works but the passenger side does not even come close to aligning up anywhere..I made my own bracket and added an extra support in the center of the diffuser..
The brackets are completly off, I will agree..The driver side works but the passenger side does not even come close to aligning up anywhere..I made my own bracket and added an extra support in the center of the diffuser..
I figured it out yesterday, what a b!tch! Both brackets do not align properly. I had to bend the crap out of the passenger side and I used a preexisting hole that was not in use. However, to get to it with that black box (what is that) was near impossible. I had the gf do it for me with her smaller hands. I would say the hardest part of the install is getting the rear brackets to fit then screwing in the "u" bracket. Good luck getting your hand or any tools behind it.
Yeah, the pictures cheston provides where the brackets go is just unclear and he even admits that they're hard to find. It would be much more helpful if someone posted pics. Do the brackets need to be bent?
^^
sorry-
when i have time this weekend i'll take some snaps and post it in the DIY-
i was just about to order my TS diffuser but then i remembered my HKS dual canister exhaust. I read that this will work but what all needs to be dremeled(sp?) for the HKS dual canister to fit without any problems? Does anyone have a decent pic of this diffuser with the Nismo rear pieces? i only read a little bit on the backet. how hard is it to make this actually fit with the bracket it came with?
