07 Auto Z question
#1
New Member
Thread Starter
iTrader: (6)
Join Date: Feb 2008
Location: Evanston/Oak Brook, IL
Posts: 432
Likes: 0
Received 0 Likes
on
0 Posts
07 Auto Z question
Hey guys im having some problems removing the interior of my car... my question is how do i remove the top 3 gauges and the cubbyhole to get access to the radio? i cant figure it out, also i cant remove the bottom half with the cupholders (section) the parking brake blocks the way to much for me to remove it, so how do i remove the three gauges, the cubbyhole, and the bottom half, the DIY is no help because its for the 03 models and i have an 07
#2
Registered User
Join Date: Feb 2008
Location: Philly Suburb
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
I have an 07 auto and i just did this yesterday to install my ipod adaptor.
Remove the silver ring around shifter (just pry it up). Next pull up and remove on the silver and black piece under where the ring was. the a/c controls are attached to it too. remove the screws that are now exposed (i think there are 3 sets of 2 screws). Now remove the screws in the cubby hole is. I have factory nav so i cant help you out to much there. Then the whole dash panel should start to come out. There is a plug on the top near the 3 gages. Once thats unpluged you should be able to pull the radio out.
Remove the silver ring around shifter (just pry it up). Next pull up and remove on the silver and black piece under where the ring was. the a/c controls are attached to it too. remove the screws that are now exposed (i think there are 3 sets of 2 screws). Now remove the screws in the cubby hole is. I have factory nav so i cant help you out to much there. Then the whole dash panel should start to come out. There is a plug on the top near the 3 gages. Once thats unpluged you should be able to pull the radio out.
Thread
Thread Starter
Forum
Replies
Last Post