I have all my wires ran through the passenger side battery bay.how do you get to the drivers side to install gauges can not find anywhere in the engine bay on that side to put in the wires. Do I have to pull out the entire dash or what, any help would be nice.

 

Go in from the passenger side rubber boot that is around the big bunch of wires entering the car. Enter into the car through there, then route them over underneath the dash.

 

I know that I stated it above is there another way to get to the drivers side.With the stero console in the way you can't just run under dash.

 

Take out the headunit, and there's loads of room behind it where wires can run through.

If you insist on running wires across your engine bay and entering through the driver side, so be it.