Does anyone know how the fitament of the Amuse front bumper with the Greddy TT FMIC/piping is? Does anyone have pix? Im lookin for a kit and need to make sure its Greddy FMIC/piping freindly!...thnkx

 

the only bumper i have seen that is pre fmic friendly i the c west or c 2. a buddy got a full cf installed yesterday and its trimed in the mouth of the bumper for the piping.. if tht helps

 

I'm also looking at the Amuse, but I want the CF splitter, any problems with installation and FI cars?

 

My buddy is Vortech supercharged and he had to trim his Amuse bumper a little for the piping to fit.

 

NISMO V2 fits the Greddy FMIC without modification.

 

I was told a PE kit woulsd fit, but i have a Greddy.

 

You need to modify the bumper to make it work with the FMIC, not the other way around.

 

damn.... i was hoping to avoid that.. How much modifying is required?

 

I wouldn't know but the trimming on my bumper was very minimal, but then again, I don't have an Amuse bumper or GReddy FMIC. If you're running the genuine Amuse bumper, since its FRP, it will be a lot easier to work with. If you have the Shine Auto replica, it may be a little more difficult as the material is a lot more flexible.

 

no, we had to trim to fit his oil cooler.

I think it would fit most FMIC setups, if it needs trimming it is very easy, just get an orbital sander and go to town.... will probably take 20 seconds

 

No modification is necessary.

 

Pls tell me u know this cause you run agreddy setup/Amuse!! You pic is too small to tell what FMIC u have..

 

What kit is that?

 

Greddy twins & Amuse bumper here

 

*Music to my ears* could you post some pix of your car pls

 

ings+1 Type-E Long Nose Full Carbon.

 

 

very nice john!!!

 

^ Thanks man, no longer the sleeper huh, lol

 

nice........... you have a front grill shot?