wow wut a pain in the ***!!!!!!!!!! I read some of the threads and I knew the passenger side was gonna give me a hard time but i didn't think it was gonna be that bad. I managed to get the job done w/o removing the bumper w/ an offset screwdriver after an hour's worth of work. I only tightened the passenger side screws a tad more than hand-tight, but I think i'll be ok.


But they sure do lQQk good

 

yeah you should be fine, not much load on them as long as they are in there. the fact that its going into plastic should lock the screws in anyway, too much and youd probably strip them.