New project I have been working on, Aluminum belly pans
#181
Registered User
iTrader: (9)
Be careful at high speeds with this, I lost my tray and so much air got up there at freeway speed that it tore the fender liner and... long story short, I'm down a fender liner for my left wheel.
So yeah.
That diffuser is definitely a good thing to have. I'm nervous as hell driving around without mine.
So yeah.
That diffuser is definitely a good thing to have. I'm nervous as hell driving around without mine.
Its funny you say that, because i was going EXTREMELY fast on a long, straight (and usually emtpy late nights) tollway here in Houston we coined, "The Autobahn".
For purposes of protecting the innocent, i wont post what speed i was going, but when i hit that EXACT mark, the shroud ripped clean off. I figured it was due to heavy air flow underneath applying downward pressure on the engine side of the shroud, but i wasnt sure.
You have confirmed my theory...
Last edited by GeauxLadyZ; 09-30-2009 at 09:43 AM.
#195
Vendor - Former Vendor
iTrader: (71)
Here are a few of my other items for the Z32
Chrome throttle linkage covers
Mirror Stainless Fuel filter brackets
I do a lot in Stainless normally so look for some more cool stuff later on. The Z33 undershrouds are taking up pretty much all of my time right now
#196
Vendor - Former Vendor
iTrader: (71)
Ad is up in the vendors section, I have the first batch of 30 done and more on the way.
Thanks everyone!
https://my350z.com/forum/body-exteri...ml#post7803588
Thanks everyone!
https://my350z.com/forum/body-exteri...ml#post7803588
#198
Vendor - Former Vendor
iTrader: (71)
Black Matte PowderCoat Sneek Peek
Just got back from picking up the PC black test runs, I had 2 pieces powder coated to make sure it was the correct color and finish I wanted before having them all done. The rest of the batch will be going to PC's tomorrow or Wednesday.
This particular texture looks a lot like Teflon.
They look even better in person!
This particular texture looks a lot like Teflon.
They look even better in person!
Last edited by ZSpeedPerformance; 10-05-2009 at 06:58 PM.
#199
New Member
iTrader: (10)
Looks good. I'm lazy and because you have to take off the entire undertray to change the oil, I don't do it myself. I figure that I could $40 a shot if I changed it myself. So... 8 oil changes and I'd have more than paid for it. With the number of miles that I'm putting on the Z, that is a bit over two years to recoup the cost.
I'm close to talking myself into it. :-)
I'm close to talking myself into it. :-)
#200
Vendor - Former Vendor
iTrader: (71)
Looks good. I'm lazy and because you have to take off the entire undertray to change the oil, I don't do it myself. I figure that I could $40 a shot if I changed it myself. So... 8 oil changes and I'd have more than paid for it. With the number of miles that I'm putting on the Z, that is a bit over two years to recoup the cost.
I'm close to talking myself into it. :-)
I'm close to talking myself into it. :-)