Anyone know wtf i can tuck the wire harness for the rear wiper??

 

from my pic thread

 

Roof liner maybe?

 

tried and was having touble sealing the liner back up and was not sure if there was a spot in the rear driverside to tuck it or pull it back to the dash or where ever it comes from and tuck it up there.

Anyone with an Asuka tell us what they did?

 

bumping an old thread since im interested for an answer...

 

Yea my damn head liner is still not right. 8(

 

I have mine tucked up next to the 3rd brake light. If you look in the back from inside, you can somewhat see its reflection. From outside, because my lexan is smoked, can't see a thing even in direct sunlight. Don't know if this helps anyone with glass.

 

I have glass but will check it out once I get my new koyo rad mod completed. Thus far the koyo rad has been the tuffest mod to complete since I run the TN turbo kit. Damn fittment issues!

 

i used a clothes hanger and taped it up and pulled it through, it took a while but eventually got it...it also helps to have a friend with little asain fingers

 

i just pulled mine through into the hatch... i hooked up the thrid tail light and just jumped the ground for the hatch glass defogger and light to the ground wire that goes back and screws to the hatch normaly... are you planning on just not having any of the hatch trim pieces or what? IMHO it kind of looks like crap without any trim so if you're going to make new trim or use the old stuff just route the wiring where it would have gone on the stock hatch. there is a multitude of devices to make wires look clean too. personally i'm going to make a one piece CF or FG trim piece to cover the ugly that will hide the wires

 

will have to check on this after I finish my koyo rad install on a TN kit settup. By far this 36mm rad is the worst mod EVER!

 

I drilled a hole bigger than oem and pulled it through.. Major PITA btw..

 

finally something that fits my application and exactly what I was thinking about doing. Just been slamed with this stupid koyo rad project. Koyo and TN does not work well in my opinion.

 

Actually I dremeled a square hole.. It looks pretty nice though..