Seibon CF CW lip DIY or install help?!
04-28-2010 | 09:58 AM
#21
So just finished the lipkit..put 2 screws near the grille black of course and 2 on each side.1 from the bottom into the bumper and one from the CF into the wheelwell(once installed) also put 3M tape under the grille area to give it a nice fit!...good project for a couple days =)...and my custom grille ...hate the OEM
Just came in 30 mins ago
Just came in 30 mins ago
05-11-2010 | 05:19 PM
#27
I didnt have a hard time with the lip, I bent the polyurethane bumper like you guys suggested. Im thinkin of posting a diy?
It was also a great oppurtunity for spraying my pipes and undercarriage with 409 cleaner and wiping it down my pipes with mothers metal polish. for some reason my pops and I have a hard time communicating though? Maybe my spanish isnt teh best lol
Enough rambling here's a pic of the finish product:
Im leaving the tape on for the rest of the day, the double sided tape should be set by morning. ill clean her up tomorrow.
It was also a great oppurtunity for spraying my pipes and undercarriage with 409 cleaner and wiping it down my pipes with mothers metal polish. for some reason my pops and I have a hard time communicating though? Maybe my spanish isnt teh best lol
Enough rambling here's a pic of the finish product:
Im leaving the tape on for the rest of the day, the double sided tape should be set by morning. ill clean her up tomorrow.
Last edited by ImWeeZzel; 05-11-2010 at 05:21 PM.
05-13-2010 | 10:54 AM
#29
My authentic Seibon lip fits on perfect..06+ year...however it was a pain to install. trick is gotta slip in one side then bring the other side of the bumper in on an angle and snaps on..unfortunately i learned the hard way and cracked the CF lip a little bit(non noticeable)
I'm gonna use 3M tape for the middlesection and screws/rivets for the 2 sides maybe a few brackets for underneath for extra support..
I'm gonna use 3M tape for the middlesection and screws/rivets for the 2 sides maybe a few brackets for underneath for extra support..
05-23-2010 | 08:17 PM
#34
Registered User
Joined: Feb 2010
Posts: 117
Likes: 0
From: El Paso, TX
I didnt have a hard time with the lip, I bent the polyurethane bumper like you guys suggested. Im thinkin of posting a diy?
It was also a great oppurtunity for spraying my pipes and undercarriage with 409 cleaner and wiping it down my pipes with mothers metal polish. for some reason my pops and I have a hard time communicating though? Maybe my spanish isnt teh best lol
Enough rambling here's a pic of the finish product:
Im leaving the tape on for the rest of the day, the double sided tape should be set by morning. ill clean her up tomorrow.
It was also a great oppurtunity for spraying my pipes and undercarriage with 409 cleaner and wiping it down my pipes with mothers metal polish. for some reason my pops and I have a hard time communicating though? Maybe my spanish isnt teh best lol
Enough rambling here's a pic of the finish product:
Im leaving the tape on for the rest of the day, the double sided tape should be set by morning. ill clean her up tomorrow.
Did you post the DIY for the polyurethane lip of yours after all?
05-24-2010 | 03:50 PM
#36
nope havent posted a diy guide yet. i left the following week, then drove to md. I was in dc for a day then flew out to france, I just got back a couple of hours ago... In other words ive been busy.
