06 carbon fiber
09-13-2010, 02:40 PM
#1
Registered User
Thread Starter
iTrader: (2)
Join Date: May 2010
Location: Broca
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
06 carbon fiber
Ok so I almost have the interior done for now. I've been trying to get the front panel 06 carbon fiber piece and the carbon fiber piece that goes around the climate control for about 2-3 months but Jay from evo-r responds once a week or once a month. Does anyone else know anyother shops people websites that make carbon fiber interiors. Thanks
09-13-2010, 05:22 PM
#2
350Z-holic
iTrader: (16)
Join Date: Aug 2006
Location: Scottsdale/coyote drophouse
Posts: 8,246
Received 414 Likes
on
237 Posts
carbon
i have evo r in my car.. the fitment was terrible, the quality is thin ( mold pressed, not hand laid) and i had to spend countless hours sanding, molding, dremel, re polishing etc to get it to fit. End result is nice, but seriously, unless you have a very steady hand and the proper knowhow... and a few hours after work for a few WEEKS.... stay away.
RUN away.
RSW is twice as expensive and worth every single solitary dollar.
You want to hear what will make you feel good or the truth? I promise you.. its money well spent.
Hope it helps.
RUN away.
RSW is twice as expensive and worth every single solitary dollar.
You want to hear what will make you feel good or the truth? I promise you.. its money well spent.
Hope it helps.
09-13-2010, 07:04 PM
#3
http://www.apsisusa.com/Iindex.htm
I posted this elsewhere on the forum but figure you didn't see it.
--------------
Here are a few pics of the work they've done for me.
Fitment is awesome with APSIS. Search APSIS and see if you can find any complaints. The only complaint I have with them is you wait a long time for it but it's worth the wait.
I posted this elsewhere on the forum but figure you didn't see it.
--------------
Here are a few pics of the work they've done for me.
Fitment is awesome with APSIS. Search APSIS and see if you can find any complaints. The only complaint I have with them is you wait a long time for it but it's worth the wait.
09-14-2010, 05:22 PM
#6
It may be a bit pricey but you know the product you're getting is good quality and can't get any better. It isn't for everyone but if you want something that will fit right and look good you might have to face that it's going to cost some. Or you can go for the cheaper readily available stuff,, on which you do a search on this forum to find many customers not too happy with what they received.
Did you see this one?
http://www.apsisusa.com/Lamination%2...ashesindex.htm
The one link didn't work for me but this one did.
Did you see this one?
http://www.apsisusa.com/Lamination%2...ashesindex.htm
The one link didn't work for me but this one did.
Last edited by RoTors350Z; 09-14-2010 at 05:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Colombo
Forced Induction
35
11-09-2020 10:27 AM
Gruppe-S
Body Interior
13
05-16-2016 10:42 PM
