Cobra Monaco Pro Seat with Buddy Club Rails Issue
10-24-2012, 08:55 AM
#1
Cobra Monaco Pro Seat with Buddy Club Rails Issue
I just picked up a brand new COBRA Monaco Pro Seat and some brand new buddy club rails and the fitment to the car is terrible. there about 2-3 inches off the mounts and I have to apply a lot of pressure to line them up any ideas? For Driver seat
10-24-2012, 10:59 AM
#2
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
Make new side mounts to go to the rails.
To wide or narrow? I had to cut and refab my buddy club mounts and make them lowewr for my Corbeau seats.
To wide or narrow? I had to cut and refab my buddy club mounts and make them lowewr for my Corbeau seats.
10-24-2012, 04:28 PM
#4
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
10-25-2012, 08:58 AM
#5
pics?
o.t. but i recommend going fixed if you're going to be the only driver for the car. less things to fail, you can get seated a little lower, and it gets rid of the tiny bit of play with a slider (more seat feedback IMO).
p.s.... https://my350z.com/forum/exterior-an...ght=buddy+club
check the welds add more welds to those seat brackets if necessary.
o.t. but i recommend going fixed if you're going to be the only driver for the car. less things to fail, you can get seated a little lower, and it gets rid of the tiny bit of play with a slider (more seat feedback IMO).
p.s.... https://my350z.com/forum/exterior-an...ght=buddy+club
check the welds add more welds to those seat brackets if necessary.
