Dunc

Can anyone tell me how to remove the engine cover Nissan Emblem. I bought a carbon fiber cover and want to remove the emblem from factory cover and install on carbon fiber cover.


Thanks

ajk4

take a very small screwdriver and pry it off very slowly at the "center bar" of the nissan emblem. its only held on with double-sided tape, so it comes off quite easily. however, you need to be careful not to chip or scratch the emblem when prying it off, cause its made of plastic and is kinda flimsy.

MSOsr

iTrader: (5)

I think it just has posts holding it to the cover, not tape. Just push them out from the inside and the emblem comes off.

ajk4

the posts guide the emblem in its place. they dont clip in there they just slide in and out without acting as a fastener.

chazzg

iTrader: (1)

Just get a new one at you Dealership $12.00

350zSpeedRacer

I popped mine out when I had my cover painted from the inside. The double sided tape wasn't terribly sticky, so I just pushed the prongs out, and voila.

Dunc

Zpresence / Rob
Said to use a heat gun on the back gun to the back and just push lightly on guide pins once you get it a little lose it just pops off and you can re-apply. Worked great !

Thanks All