FS/FT: 350Z APR Spoiler
These are the spec's for the wing. The price is for the main land U.S. I would have to check out what pricing would be for Hawaii. The GTC-300 350Z Spec Wing fits the contour of the 350Z rear trunk. Drilling will be required to attach the wing pedestals.
Specs: Wing Span 67" (1700mm); Post Heights 13" (330mm); Distance between posts 36" (915mm)
Also, check out htis site for more details about the spec's; http://intensepower.com/aprgtcafiwi3.html
Specs: Wing Span 67" (1700mm); Post Heights 13" (330mm); Distance between posts 36" (915mm)
Also, check out htis site for more details about the spec's; http://intensepower.com/aprgtcafiwi3.html
Bolt on is simple. Masking tape and a tap measure to center it was all i needed. The price listed above is what you pay for shipping anywhere in the lower 48 states. So, to California you'd only pay $900.
Last edited by Dustman; Apr 21, 2011 at 11:17 AM.
Trending Topics
I just did this recently.....
https://my350z.com/forum/exterior-an...or-a-wing.html
However, I used a GTC-200 wing which is considerably smaller. The 300 is MUCH larger. According to APR's website, it can generate 300 lbs of downforce - a lot of stress on a CF hatch.
$900 is an awesome deal though!
https://my350z.com/forum/exterior-an...or-a-wing.html
However, I used a GTC-200 wing which is considerably smaller. The 300 is MUCH larger. According to APR's website, it can generate 300 lbs of downforce - a lot of stress on a CF hatch.
$900 is an awesome deal though!
hmm, too bad.. im in the market for a SBC wing too...
But the gtc300 are $1074 and local and new at intense.. im looking for one, but would just buy it new at that price... just a heads up that the price may be the factor holding you back from selling it.
But the gtc300 are $1074 and local and new at intense.. im looking for one, but would just buy it new at that price... just a heads up that the price may be the factor holding you back from selling it.
APR Spoiler
Here are some additional pictures of the spoiler prior to being attached to the car. You line up the two guides, tape them down, mark the spot for the four holes and drill through the hatch. Any brace or support on the inside of the hatch is something you would have to fabricate.
Last edited by Dustman; May 9, 2011 at 09:20 AM.
You sent a deposit? If you look above your post, you'll see I already sent one. I have actually sent the full payment now. Please respond.
I completed payment today after sending a deposit a few days ago.
I completed payment today after sending a deposit a few days ago.
