going to be installing the blitz boost controller tomorrow morning..i intend on keeping the e-01 brain and greddy pressure sensor intact..any pointers for me for those of you who have done this already? any special instructions or words of wisdom that may save me some trouble?

...and no "read the instructions" as advice, i plan on doing that

also, for those of you with the sbd ic..any feedback on how u like this boost controller? any tips on gettin git set up?

thanks everyone!!!!

 

Its pretty straight forward for hooking it up. Just make sure you hook it up wastegate style, and have it set to manual and not auto. And just start with the gain and set at 0 and move up until you feel your where you need to be. Its pretty easy.

 

cool..thanks the install will begin in about an hour,,,, going to pick up the BC now

TODD

 

On my Turbonetics, the max gain I could set without overboosting was 27.

 

Was that on manual or auto?

 

install was very easy..thx for some of the ideas...
my set is on 42, gain 70...this makes 16.5 psi

i have .8 bar wastegate springs

 

My set is around 15 and gain is around 70 I think. It makes about 8.5 psi. It initially spikes like 8.9-9.2, but its a solid 8.5 across the board.

 

Glad it worked out for you Todd.

-David

 

thanks again!!!

 

gain 70, woah, i think mine is around 40, it must build boost fast.

 

yah, i had it on gain 90..it overboosted a little too much at first...70 overboosts to like 17/17.5 for a split second, then it drops to a steady 16-16.5

 

Real quick. I like it like that. I tried with a lower gain, and it was like come on already!