^^Its more of a rhetorical question but here's whats in the works for right now. Doing my build peice by peice Much cheaper. Here we go:

Ferrea +1mm Comp Plus Stainless Intake/ Exhaust Valves
Ferrea S10093 Springs
Ferrea E11058 TI- Retainers
Ferrea S11048 Spring locators
Ferrea Vs1014 Brass/ Manganese Valve guides
Ferrea Intake/ Exhaust Valve seals
Ferrea TI-Valve locks

Port & Polished Intake and Exhaust
5 angle Valve Job
1mm over
Deshrouding the valve seats

So far "knock on wood" if every thing goes right; I'll have all the parts; including the heads for arround DIRT CHEAP. All Ferrea parts are new and warrentied. I found a good distributer, if every thing turns out ok I'll give feed back on who they are if I get PM'd. They are not affiliated with the site so I'm not gonna passout info in an open forum.

I already have a set of JWT S1 cams lying arround so those are going in. Hoping this set up will help out the bottom end I'm getting together this winter.

 

Sounds like a nice package you have setup...