alright heres the dilemna

my turbo kit is almost done being fabbed up. so anyway, i have a g35. but the kit utilizes two smaller intercooler cores to fit up both sides of the front bumper.

but, they are on national backorder. completely gone and wont be back till august. Bell intercoolers wont be able to make one till 2 weeks and Precision cores dont have any that small.

well this just sucks. and im on a huge time restraint because i have scheduled photo shoots, BIG ones, and theres no time to wait.

so what should i do?? get one off ebay and have them chop it up, not a good idea. or put the Single intercooler core from a Z on it? will it even fit?

putting the single one has a few advantages. vertical flow and bigger core, good to around 700 hp. not to mention its more readily available?

any other suggestions?

 

also, if i do use the 350Z intercooler, will it even fit on a G35 front end with stock bumper?

 

Do you know the dementions of the twin coolers ? If so , I would think you could have some fabbed up for you

 

i didn't see you mention it in your original post, but have you tried Spearco/Turbonetics. they make custom cores to spec... LINK

 

get the spearco IC from turbonetics that they use in their G35 kit.....

 

You could either use the Spearco one that is used in the Turbonetics kit or you could call them and tell them what dimensions you need and they can make them for you.

 

yea, thats what im gonna do. I found a vertical flow core that is 6 inches height and 25 inches wide. they can just cut little cores off and Spearco has that one in stock. The two smaller ones are gone so at least now i can get that one by Spearco and have it all cut up to get it to work right.

 

There you go

 

bascially that thing is huge, but will work when u chop it up