~"V-Mount" Radiator Support frames for Turbo Applications~
#22
Registered User
Thread Starter
Join Date: Mar 2006
Location: Palm Beach County, FL
Posts: 209
Likes: 0
Received 0 Likes
on
0 Posts
I have a fabricator who will know what to do.... from what I see on that G... its very doable and I like the design... I dont have an oil cooler like they do but all the rest is there!
...An for what someone mentioned about the amount of money spent on making a v mount being high priced... wrong answer there... sorry, its a lot cheaper than doing the air to water set up that you mentioned. i like the air to water and i agree with its works, but v mount is the route i plan to go.. ie, the reason why i posted this thread thanks!
i did my research before i posted, ... i was just looking to see who in south florida knew of any fabricators... and i found one. oh an, someone said y even do the project anyway.... umm, you must have missed the part where i said i cracked my radiator support... im gonna need something there anyway... may as well do this project, no?
i like to keep my posts as professional as possible so lets keep the opinions to ourselves.
thanks again for that g photo... excellent set up i must admit!.. i think my guy can mimic that set up pretty well! ...project takes place in october after my next event... ill revive this topic when photos arise!
...An for what someone mentioned about the amount of money spent on making a v mount being high priced... wrong answer there... sorry, its a lot cheaper than doing the air to water set up that you mentioned. i like the air to water and i agree with its works, but v mount is the route i plan to go.. ie, the reason why i posted this thread thanks!
i did my research before i posted, ... i was just looking to see who in south florida knew of any fabricators... and i found one. oh an, someone said y even do the project anyway.... umm, you must have missed the part where i said i cracked my radiator support... im gonna need something there anyway... may as well do this project, no?
i like to keep my posts as professional as possible so lets keep the opinions to ourselves.
thanks again for that g photo... excellent set up i must admit!.. i think my guy can mimic that set up pretty well! ...project takes place in october after my next event... ill revive this topic when photos arise!
Last edited by Three5oZee; 08-06-2007 at 10:49 PM.
#25
Registered User
iTrader: (14)
OP
While I understand your point about wanting a v-mount I do disagree about a air-to-water intercooler being more expensive. In all honesty, it would most likely be about the same cost from what I have calculated and I went with the air-to-air based of the simplicity and lack of parts to fail. However, there is the chance that there were additional things in my calculations that made it seem equal that may not be in yours.
Either way good luck!
While I understand your point about wanting a v-mount I do disagree about a air-to-water intercooler being more expensive. In all honesty, it would most likely be about the same cost from what I have calculated and I went with the air-to-air based of the simplicity and lack of parts to fail. However, there is the chance that there were additional things in my calculations that made it seem equal that may not be in yours.
Either way good luck!
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM