350z vortech auto
09-17-2007, 12:32 PM
#1
Registered User
Thread Starter
Join Date: Sep 2007
Location: Rancho Cucamonga, CA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
350z vortech auto
i am thinking of ordering a vortech system for the 350z. but i am not sure how to upgrade the transmission in order to support the power of the supercharger. the 350z is a 05 with only 18000 miles on it and i dont want to destroy the engine
09-17-2007, 01:45 PM
#3
Registered User
iTrader: (9)
Join Date: Jul 2003
Location: Davie/Lutz, Florida
Posts: 1,918
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by sentry65
there's lots of people on bone stock autos doing just fine. A lot of people use manual mode though and shift a little early to give the tranny time to shift when it hits redline
+1, this is actually stated in the Vortech Installation Manual.
09-17-2007, 01:52 PM
#4
If you are leaving the stock 3.33 pulley on and have no plans on increasing the power other than tuning . Leaving the tranny alone will be fine . You can get a valve body done so the tranny will shift faster and harder . It will also shift before hitting the rev limiter . Hitting the rev limiter in full auto mode is the main problem you will incounter . Getting a VB done will also hurt the smoothness of the tranny . Shifts can be hard.....1st to 2nd shift is actually to hard at low rpm's....you have to get used to it .
Thread
Thread Starter
Forum
Replies
Last Post
seagrasser
Zs & Gs For Sale
6
10-11-2015 03:27 PM
hardkicks
Zs & Gs For Sale
0
09-20-2015 12:28 PM
