Greddy vs. APS
Ok so i've been doing some research on who makes the best tt and i've narrowed it down to 2. it looks like greddy would make a better drag car
( https://my350z.com/forum/drag/233840-top-25-1-4-mile-times-for-tt-st-supercharger-nitrous-bolt-ons-stock.html )
but i've heard that the kit comes less complete then the aps
but the greddy is less expensive
well i dont know what to do
i plan to build up the engine either way and make my z an absolute beast
( https://my350z.com/forum/drag/233840-top-25-1-4-mile-times-for-tt-st-supercharger-nitrous-bolt-ons-stock.html )
but i've heard that the kit comes less complete then the aps
but the greddy is less expensive
well i dont know what to do
i plan to build up the engine either way and make my z an absolute beast
Greddy! For the fact you have more power potential..but the APS Extreme is BALLER!!! But if you are super baller Sound Performance twin 60trim turbos!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Trending Topics
Depends on what you want. APS theoretically SHOULD give you less spool time and faster response due to the ball-bearing, but the two are VERY close.
I ended up going APS because I think the kit looks better in the engine bay and I liked the idea of BB water-cooled turbos mostly. Plus I got my kit with a killer deal.
You can't go wrong either way.
Just my 2 cents.
I ended up going APS because I think the kit looks better in the engine bay and I liked the idea of BB water-cooled turbos mostly. Plus I got my kit with a killer deal.
You can't go wrong either way.
Just my 2 cents.
Originally Posted by XIceDragonX
i always loved the sound of greddy's with an open dump setup.
well there wouldn't really be a diff there...open dumb is open dump.
that mor depends on the size of waste gate and the size of the dump pipe
Well . . are you referencing to me?
I went on the Dyno same day, right after a friend's built GReddy TT G35.
I had more torque (i think between 50-100, I can't remember) than he had at the same RPMs. (around 2500)
Also he was pushing 16psi, I'm only pushing 9psi. I don't know if that is a factor in spool time.
I went on the Dyno same day, right after a friend's built GReddy TT G35.
I had more torque (i think between 50-100, I can't remember) than he had at the same RPMs. (around 2500)
Also he was pushing 16psi, I'm only pushing 9psi. I don't know if that is a factor in spool time.
Thread
Thread Starter
Forum
Replies
Last Post
bcoffee20
Zs & Gs For Sale
5
Nov 19, 2015 06:39 PM
BlinkerFluid
Engine
0
Sep 8, 2015 10:06 AM





