if anyone has installed theyre kit do they know which wires they tapped into which color or pin numbers for the crank and cam sensors?? everytime i call stillen seems like i get a different answer

 

PM SuperCharged G.... I second the crank sensor...fuel is not "really" affected on the Stillen Install... Check Altenator also. Battery maybe turning things for now.

 

if the CPS isnt reading correctly/there is a problem with the reluctor ring, you dont get a spark. as soon as the ECU reads a problem from the CPS, such as extra blips, short/long blips, etc. then it stops sending spark signals. it is also possible to have that problem and not get a code for it.

 

Dont pm me as it has been so long since i installed the sc i cant remember.And now that i installed the twins i def cant remember........plus i no longer have the instructions.

 

I chuckled when i read don't pm me... lol

 

Vacuum leak? Nice to see someone actually go with the stillen.

 

OP indicated to me that he has not installed the walbro fuel pump needed for this kit to function properly which could be one of the solutions to his problem.

Also he stated that he has a non rev up model but his kit has a gold pulley which is for rev ups only. The SS box comes pre tuned for this type of engine so this could also explain the problem. Only real solution here is to purchase a stage 4 for non rev up which would replace the rev up pulley and ss box????

 

Now that comment made me laugh.

 

(1) Did you use the fuse clamp Stillen gave you? And, did you then push the fuse box cover back on? Try giggling the connection and trying it again without the fuse cover on. Sounds like your fuel pump relay. Cranks but won't run...

(2) Is your intercooler pump cycling fluid too???

(3) Pull your intake by the throttle body and spray carb cleaner into the intake and see if it runs. If so, then you have a problem with fuel delivery.


My 2 cents...

 

i'm not sure what laughing at it will do... or perhaps you meant to jiggle it...