Who has replaced their stock ATI valve with a louder aftermarket BOV ?

If you have, what did you use and what are your impressions ?

--wes

 

I think at least 2 members on this board with the ATI have used this BOV to some success: http://cgi.ebay.com/ebaymotors/ws/eB...category=33742

Do a search for daking350 or turboxs and i think you might find the install someone posted. You also need something to plug the other end of the IC piping that was originally connected to the ATI surge valve. I think its some sort of rubber disk that can be inserted into a pipe and then you tighten the screw in the center and it expands to make a air tight seal.

 

Cool...I'll check those links out.

I know the rubber disk you're talking about....i used a couple of those from Home Depot when i plugged the stock recirculation valves on my 300tt after I swapped to the Blitz BOV's


Thanks man.

--wes

 

Ahh I found that post, but it was form another 350Z forum. It has the complete write up of the install/swap. http://**********.com/forums/tutorial...&CODE=02&id=13

I might do this mod too since alot of ppl say the stock ATI surge valve is weak.