I finally got my new belt, and frankly, I'm not sure how to install it. I have the manual but it isn't real clear on how to install this belt, but clearly outlines the other two belts.

Any tips on install of the SC cog belt on the rear of the unit ???

--wes

 

Any of the self installers wanna help me out??? I need boost back...had a neck/neck run with a WRX today....that just aint right.

--wes

 

Wes,
You have to loosen but not remove the smaller allen bolts that allow you to turn the pully shaft housing. These are located on the front and are attached into the slotted parts. Then take the top most rear pully apart by loosening the small allen bolts on the pully itself. With the front three allen bolts loosen but not removed try to rotate the pully shaft housing and remove the belt. Same to put it back on. PM me for further info.
MIKE

 

belt is on and boost is good...thanks man.

Had a little trouble with one of the allen head bolts....turns out one was stripped...that took some doing but we're all good now.


BOOOOOOOSSSTTTT!!!

--wes

 

Tore up the rear cog belt??Aint it a biatch!!