Stillen Stage 3 (2004.5) - 347rwhp - dynapack
#1
Registered User
Thread Starter
iTrader: (3)
Join Date: Jul 2002
Location: Seattle
Posts: 1,182
Likes: 0
Received 0 Likes
on
0 Posts
Stillen Stage 3 (2004.5) - 347rwhp - dynapack
Just got my car dynoed on a dynapack, just for the experience really but it turns out that everything is working in harmony .... even the Service Engine Soon light has gone off :-)
I'll post the sheets tomorrow but here are the numbers ....
Rear wheels (axle)
347 hp at 6424
not sure about torque, sheet says 1028ft/lbs !!! ...
Flywheel (calc'd by dynapack software)
419 hp at 6424
346 ft/lb at 4219
I am not sure how these correspond to dynojet numbers and for the benefit of the team, I'll go and dyno this week (if they can fit me in ...)
Anyways, I'm really happy with the whole setup, thanks to all who helped me with everything ... (Nilo, Jim etc)
Colin
P.s. New shot taken today at a NWN meet .....
I'll post the sheets tomorrow but here are the numbers ....
Rear wheels (axle)
347 hp at 6424
not sure about torque, sheet says 1028ft/lbs !!! ...
Flywheel (calc'd by dynapack software)
419 hp at 6424
346 ft/lb at 4219
I am not sure how these correspond to dynojet numbers and for the benefit of the team, I'll go and dyno this week (if they can fit me in ...)
Anyways, I'm really happy with the whole setup, thanks to all who helped me with everything ... (Nilo, Jim etc)
Colin
P.s. New shot taken today at a NWN meet .....
#2
Registered User
Join Date: Nov 2002
Location: Washington State
Posts: 113
Likes: 0
Received 0 Likes
on
0 Posts
Colin,
Great to finally meet you...Congrats again on those numbers! Btw, how was that meet? Wish I coulda made it. It was such a nice day. Oh well, next Sunday.
Nilo
Great to finally meet you...Congrats again on those numbers! Btw, how was that meet? Wish I coulda made it. It was such a nice day. Oh well, next Sunday.
Nilo
Thread
Thread Starter
Forum
Replies
Last Post