I need help removing the JWT popcharger. I loosened the speed ring but could not the filter to come off. Do you have to unscrew the filter? Any help is greatly appreciated.

 

dude, install instructions at www.jimwolftechnology.com

 

Perhaps I wasn't clear enough...I am trying to clean the pop charge, and I would to remove it quickly and easily without taking off all 4 bolts from the back. I have installed it as it has run very well for about 5k miles, which is when I was told clean the filter

 

cleaning instructions also on that site.

 

I'm pretty certain it is every 50K!!!

 

filter should slide right off with the loosening of that speed-ring screw, if you installed it correctly, which is why i referred you back to install instructions.

 

Replacement Filter
http://performancenissanparts.com/ca...roducts_id=593

How do I go about cleaning the filter?

You do not have to remove the whole Pop-Charger from the MAF Housing. There is a large clamp that holds the filter element on the velocity ring. Loosen this clamp and remove the filter. Rinse the filter from the Inside-Out (have water flow out of the filter in the oposite direction in which the air travels into the filter). Rinse until the water runs clear. Let the filter element dry for 30-40 Minutes (sitting over crumpled up newspaper helps speed the drying process). Once the filter is dry, apply oil to the out side of the filter (do NOT over oil). Let the filter dry for another 45 minutes. If any white spots appear apply another spray of oil and let dry. Once the filter is dry and no oil is dripping, re-install the filter and tighten the clamp

 

Moved.